In this post, I have discussed a list of the ice maker replacement parts to repair the machine. If the ice maker or refrigerator/freezer is not producing ice, then obviously something is wrong. It may be something simple such as a frozen line or you may need to replace a part to run the machine.
Getting the right ice maker replacement parts will help ensure your ice maker is running smoothly again. Otherwise, you may suffer for a long time.
Buying a brand new icemaker might cost you more than repairing the unit but sometimes this is fine for the owner. The new unit will have a certain warranty on its parts and compressor. So you don’t have to worry during the warranty period.
What are Ice Maker Replacement Parts?
The ice maker, refrigerator, or as a stand-alone device consists of several different parts. Run by electricity, there is generally a motor, fan, and cooling elements inside the device. Each of these elements consists of different parts that make up the functioning part of the ice maker.
As with most appliances, ice makers have parts contained within larger units. For example, if a part within the motor breaks down, you can purchase a new motor instead of just the part. This makes replacement easier because you are replacing a device instead of the individual part itself.
Replacement parts for ice makers are generally purchased by professional appliance repair services as part of their job. In most cases, they will not have the parts on-hand. They will instead inspect the ice maker and order the parts that are necessary.
List of the Ice Maker Replacement Parts
Here are some parts that you may need to repair the ice maker. Moreover, there are more parts so look at your local hardware store.
1. Compressor: It is a very important part of every cooling system to heat and pressurize refrigerants. If you have no idea that the compressor is bad or fails to work, you can check out this guide.
2. Inlet valve: It is usually located at the rear of the unit to draw in freshwater or simply acts as a kind of gatekeeper.
3. Drain Valve: Works for proper drainage of water.
4. Door Gasket: The intact door gasket acts as an airtight seal.
5. Water Level / Temperature Sensor: It is a detector of temperature and water level.
6. Condensation Sensor: Condensation level detector.
Professional or Do-It-Yourself?
The simplest course of action when you cannot identify the issue or when you have narrowed it down to replacing a part is to call a professional. You can either contact the company where you purchased the machine or an independent appliance repair service.
Before you make the call, see if your cooler or refrigerator is covered under a warranty. Chances are if the machine is less than a year old, then the ice maker might be covered. However, you will need to read the warranty to ensure that it is covered. This means if the ice maker is part of a refrigerator, you’ll need to check the list of parts or areas that are not covered.
Calling a professional means that you get the work accomplished by someone who guarantees that the job will be completed properly. A licensed, insured professional means that they have met state requirements and are covered in case they accidentally cause damage or injury to someone in the process of doing the work.
The upside is that the reputable ones guarantee their work. The downside is that you pay considerably more to have a professional do the job compared to purchasing the ice maker replacement parts and doing the work yourself.
If you have some experience in replacing parts or repairing appliances, then this should be a no-brainer. Unless the design of the machine is such that access to the parts is difficult at best, you can do the work yourself if you have correctly identified the parts that need to be replaced.
Remember to start by unplugging the machine first. Then, open the ice maker and begin the replacement process. You may find a schematic of the ice maker online or from the company that manufactured the appliance.
Next, make sure you have the right tools such as a screwdriver and pliers to hold the parts in place. You just need to disconnect and remove the broken part or device, then install the replacement part and connect it back to the electrical source if necessary. Once completed, plug the ice maker back in and run a test.
- Used Ice Maker
- Nugget Ice Maker
- 5 Best Commercial Beverage Dispenser Units
- 7 Best Commercial Washing Machine
- How to Wash Clothes in a Washing Machine
- 5 Best Commercial Ice Cream Maker
- How to Make Ice Cream with an Electric Ice Cream Maker
- How Do You Know If Your Refrigerator Compressor Is Bad?
Where to Purchase the Parts?
You can start with the manufacturer, but there are companies that sell ice maker replacement parts on the web. Either way, you will need to correctly identify the part itself by its serial or part number. Then locate it in the catalog. Once you make the purchase, then you will receive the part as fast as it can be shipped.
Again, it helps if you replace the entire device instead of the individual part as that is generally easier, albeit more expensive. The exceptions would be parts that are independent of other devices inside the ice maker such as the lid or container.
If you have an ice maker, chances are at some point it will need new parts. By purchasing the right ice maker replacement parts, you can repair your ice maker quickly and have it running at full efficiency again.